At the moment, the casing is attached to the clamps.To do this, unscrew the handle with a 10 bolt. The best solution would be to remove the Nissan Qashqai door trim along with the handle. The inner door handle is connected to the skin with metal brackets.It will need to be removed after the chip is turned off. Do the joint as calmly as you would the patch. Be careful with latches, they are fragile. To do this, carefully pull it out of the corner and gently and slowly unhook it. The front right door of the Nissan Qashqai J10 is arranged as follows: Small screwdriver (as thin as possible).On the example of the right front door, also a brief description of the case. I'm removing the door trim on the Nissan Qashqai 2012 onwards. It is recommended to disconnect the ground cable from the battery in order to properly remove the tailgate trim. This is not the only way to remove the door trim on a Nissan Qashqai J10, but it may be the easiest of all. But if it closes and opens as badly as before, you need to find out what else could be the problem. If the passenger door of your car did not close or open, but began to open normally after such an operation, the problem is solved. It will take no more than 30 minutes and your doors will close smoothly. The left rear door is assembled in the reverse order.We remove the device from there, but be careful, as these seals are quite fragile and thin. Find the two seals on the plastic device to open the doors.Remove the moving part and take it out the door.Using the E6 key, unscrew the screw holding the static part of the handle. ![]() Find the cover and remove it (at the end of the door).Locate the cables coming from the power window.When used, it opens the child lock on the Nissan Qashqai front left door (if it is in the “closed” position) when the doors cannot be opened from the outside and from the inside.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |